Royal 580 - Programming Alphanumeric Descriptions (Continued); To Program a Commercial Message

PROGRAMMING ALPHANUMERIC DESCRIPTIONS (Continued)
TO PROGRAM A COMMERCIAL MESSAGE
Note: The commercial message can be set to print directly under the store logo at the top or bottom of the receipt by
changing the setting in Flag 8, Option 8 on Page 55.
STEP 1:
Before proceeding with the actual Commerical Message progr amming, fill out the worksheet s (Steps 1, 2 & 3) from
Page 45.
Example of Commercial Message:
┌─────────────┐
│ COFFEES │
│ FRESHLY │
│ GROUND │
│ TO YOUR │
│ ORDER │
└─────────────┘
STEP 2:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS the [CLERK] key, or
if you did not program a Manager Password, go to Step 3.
3. TYPE (26), PRESS [QTY/TIME], TYPE (the total number of lines to be programmed, maximum 5 lines) ,
then PRESS the [AMT TEND/TOTAL] key.
Example: To program 5 lines:
"PRG" + (26) + [QTY/TIME] + (5) + [AMT TEND/TOTAL]
4. 1st Line: TYPE (27), PRESS [QTY/TIME], ENTER (the first line of the message - 24 characters, maximum),
then the [AMT TEND/TOTAL] key.
5. 2nd Line: TYPE (28) , PRESS [QTY/TIME] , ENTER (the second line of the message - 24 characters,
maximum), then the [AMT TEND/TOTAL] key.
6. 3rd Line: TYPE (29), PRESS [QTY/TIME] , ENTER (the third line of the message - 24 characters,
maximum), then the [AMT TEND/TOTAL] key.
7. 4th Line: TYPE (30), PRESS [QTY/TIME] , ENTER (the fourth line of the message - 24 characters,
maximum), then the [AMT TEND/TOTAL] key.
8. 5th Line: TYPE (31), PRESS [QTY/TIME], ENTER (the fifth line of the message - 24 characters, maximum),
then the [AMT TEND/TOTAL] key.
NOTE: If you wish to change the programming of any lines it is only necessary to re-enter the number of the line you wish to
change and continue with the procedure above.
Example: If you wish to change the wording in line 3, TYPE (29), PRESS [QTY/TIME], ENTER (the third line of the
logo - 24 characters, maximum), then PRESS the [AMT TEND/TOTAL] key.
If you wish to print less than 5 lines for the commercial message, at item number 3, enter the number of lines desired. If you
enter only 2 lines, just the first two lines of the logo will pr int. The number of lines printed will be counted from the firs t line of
the logo.
47