(Continued) PROGRAMMING ALPHANUMERIC DESCRIPTIONS
PRINTED RESULT - EXAMPLE OF PROGRAMMED STORE LOGO:
┌───────────────────────────┐
│ │
│ INTERNATIONAL COFFEES │
│ 999-555-1111 │
│ 222 EAST MAIN STREET │
│ OPEN 7AM TO 6PM │
│ COFFEES OF THE WORLD │
│ │
└───────────────────────────┘
Step 4: Program your logo
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS the [CLERK] key, or
if you did not program a Manager Password, go to Step 3.
3. TYPE (20), PRESS [QTY/TIME], TYPE (total of lines to be programmed - 5 lines, maximum) , then PRESS
the [AMT TEND/TOTAL] key.
Example: To program 5 lines:
"PRG" + (20) + [QTY/TIME] + (5) + [AMT TEND/TOTAL]
4. 1st Line: TYPE (21), PRESS [QTY/TIME], ENTER (the first line of the logo - 24 characters, maximum), then
the [AMT TEND/TOTAL] key.
5. 2nd Line: TYPE (22), PRESS [QTY/TIME], ENTER (the second line of the logo - 24 characters, maximum) ,
then the [AMT TEND/TOTAL] key.
6. 3rd Line: TYPE (23), PRESS [QTY/TIME] , ENTER (the third line of the logo - 24 characters, maximum) ,
then the [AMT TEND/TOTAL] key.
7. 4th Line: TYPE (24), PRESS [QTY/TIME], ENTER (the fourth line of the logo - 24 characters, maximum),
then the [AMT TEND/TOTAL] key.
8. 5th Line: TYPE (25), PRESS [QTY/TIME], ENTER (the fifth line of the logo - 24 characters, maximum), then
the [AMT TEND/TOTAL] key.
NOTE: If you wish to change the programming of any lines it is only necessary to re-enter the number of the line you wish to
change and continue with the procedure above.
Example: If you wish to change the wording in line 3, TYPE (23), PRESS [QTY/TIME], ENTER (the third line of the
logo - 24 characters, maximum), then PRESS the [AMT TEND/TOTAL] key.
If you wish to print less than 5 lines for t he logo, at Step 4, Number 3, enter the number of lines desired. If you enter only 2
lines, just the first two lines of the logo will print. The number of lines printed will be counted from the first line of the logo.
Example:
3. TYPE (20), PRESS [QTY/TIME], TYPE (2), then PRESS the [AMT TEND/TOTAL] key.
Only the following portion of the default logo will print:
1st Line: **************
2nd Line: YOUR RECEIPT
46
To Next Page
Loading...
