Royal 580 - To Program the Training Manager Password; To Use the Training Password; To Shut Off the Training Mode

TO PROGRAM THE TRAINING MANAGER PASSWORD
The optional Training Mode is designed to help you become better acquainted with the register mode and offers an
ideal place for beginners to practice transaction examples. When in the Training Mode, the word "TRAINING" prints
after each transaction. The Training Mode can be activated at any time since it does not re cord any activity in the
machine totals.
A Training Mode Password is required to turn on the Training Mode. The same password is used to turn it off.
TO PROGRAM THE TRAINING MODE PASSWORD
"PRG" + (17) + [QTY/TIME] + (TRAINING PASSWORD #) + [AMT TEND/TOTAL]
1-4 digits
Example: If the Training Password is 999:
1. Turn the key to the "PRG" (PROGRAM) position.
2. If a Manager Password has been programmed, TYPE the (PASSWORD #), then PRESS the [CLERK]
key, or if you did not program a Manager Password, go to Step 3.
3. TYPE (17), PRESS [QTY/TIME], TYPE (999), then PRESS the [AMT TEND/TOTAL] key.
TO USE THE TRAINING PASSWORD
1. TO TURN ON THE TRAINING MODE
Example:
1. Turn the key to the "X" position.
2 If and X or Z position password has been progra mmed, TYPE the (X/Z position password #), then
PRESS the [CLERK] key, or if you did not program an X/Z position password, go to Step 3.
3. TYPE (999 - the preset Training Password), then PRESS the [CHG] key.
4. Turn the key to the "REG" (REGISTER) position to practice register operations.
Note: While the Training Mode is active, the operations w ill not be counted as transactions. After exiting from the
Training Mode, the Transaction Counter will resume.
2. TO SHUT OFF THE TRAINING MODE
When the Training Mode is on, its mode is shut off by the following operation:
"X" + (Preset Training Password #) + [CHG]
1. Turn the key to the "X" position.
2 If and X or Z position password has been progra mmed, TYPE the (X/Z position password #), then
PRESS the [CLERK] key, or if you did not program an X/Z position password, go to Step 3.
3. TYPE (999 - the preset Training Passw ord), the PRESS the [CHG] key. The Training Mode is now
inactive.
4. Turn the key to the position desired.
37