Royal Alpha5000ML - Installing the Memory Backup Batteries

9 Alpha5000ML owner’s manual
If you make a mistake or enter a wrong setting during initial setup, just continue with
the rest of the initial setup. During initial setup, you cannot change settings after you
press the enter key. When you complete the initial setup, you can correct any setting
by following the instructions listed in this manual.
Make sure that you plug the cash register into the electrical outlet before you put in
the batteries.
Caution
If you put the batteries in first, they can damage the cash register.
Do not use this cash register outdoors in the rain or near any source of
liquid.
After plugging power into the cash register, the 4-line LCD screen prompts you
through the rest of the set up. Use the Up and Down arrow keys to move through
the items on the screen.
Note
If you make a mistake while you are programming, press the clear key.
To get the cash register ready to use
1 Remove the cash register and the parts from the box. Store the box and packing
material in a safe and dry place. The box may be reuse in the future while
moving to another location.
2 Remove any tape on the cash register. For example, there may be tape on
the Journal Compartment Cover.
Put the cash register on hard and stable service. Keep away from rain and
liquids. A stable service allows the cash drawer to go in and out smoothly.
Do not put the register on a porous surface. Do not place the register on any
valuable surface, such as antique or fine wood tables, desks, etc. Depending
on the surface or any cleaning solution used on the surface, the rubber feet may
leave marks on the surface.
3 Plug the cash register into a grounded three-hole electrical wall outlet. (115~120
volt, 60 hertz). Make sure the electrical cord is placed safely and will not cause
accidents such as the wire being trip over or accidentally pulled from the
electrical outlet.
Put the cash register on an electrical circuit with no other electrical device or
appliance. Other appliances can overload the circuit or cause electrical
interference with the cash register. It is best that you use a circuit without other
appliances already on it.
Now follow the prompts on the screen. The rest of this chapter explains the setup
options.