Enabling Automatic User Activation with Zero-IT
300 Ruckus Wireless, Inc.
Enabling Automatic User Activation with
Zero-IT
Ruckus Wireless Zero-IT Activation allows network users to self-activate their
devices for secure access to your wireless networks with no manual configuration
required by the network administrator. Once your ZoneFlex network is set up, you
need only direct users to the Activation URL, and they will be able to automatically
authenticate themselves to securely access your wireless LAN.
Before enabling Zero-IT, make sure you have at least one of each of the following
configured:
•A WLAN configured (Configure > WLANs)
• A user Role with access to this WLAN (Configure > Roles)
•A User with this role assigned that exists in either the internal database or an
external RADIUS, Active Directory or LDAP server (Configure > Users)
To enable Zero-IT activation, do the following:
1 Go to Configure > WLANs.
2 Click Edit on the WLAN where you want to enable Zero-IT Activation.
3 Enable WPA2 (not WPA-Mixed; selecting WPA-Mixed will disable the Zero-IT
option).
4 Enter a passphrase. (This passphrase will only be used for administrator testing
- you will not need to provide this passphrase to end users.)
5 Enable Zero-IT Activation.
6 Optionally, enable Dynamic PSK if your WLAN’s authentication and encryption
methods support it (Open authentication and WPA2 encryption only; see
Working with Dynamic Pre-Shared Keys for more information.)
7 If the Authentication Method is 802.1X or MAC Address, select which
Authentication Server to authenticate users against. If you are not using an
external server for authentication, you can use ZoneDirector’s internal database.
8 Note the Activation URL in the Zero-IT Activation section further down the page.
9 Click OK to save your settings.
To Next Page
Loading...
Need help?
General
