DescriptionSetting
This option lets you select the channel used by the
network. You can choose SmartSelect, or choose one of
a specific number of channels. If you choose SmartSelect,
the AP automatically selects the best channel
(encountering the least interference) to transmit the signal.
Channel
On 802.11n/ac APs, the option to choose 40MHz channel
width provides (theoretically) double the data capacity of
a 20MHz channel. However, wider channel width means
fewer channels available, and more interference with other
wireless signals.
Channel Width (11n/ac
APs only)
This option (if enabled) lets you select your country or
region code.
CAUTION! Selecting the incorrect country or region may
result in violation of applicable laws. If you purchased the
AP in the United States, you do not need to set the
country code manually. Ruckus Wireless devices that are
sold in the US are preconfigured with the correct country
code and this setting is non-configurable.
Country Code
Refer to
Configuring Common Advanced Settings on page 102.
Advanced Settings
Select Enabled to support AeroScout RFID tag detection.
To check the status of the AeroScout communication
agent (which relays location data from AeroScout Tags
to the AeroScout Engine), go to the Status > Wireless
page. Refer to Viewing Common Wireless Settings for
more information.
NOTE For other AeroScout-related configuration, refer
to the AeroScout documentation that was shipped with
your AeroScout Tag and AeroScout Engine.
NOTE If ZoneDirector exists on the network, then you
can enable AeroScout RFID tag detection on all its
managed APs at once. Refer to the ZoneDirector online
help for more information.
AeroScout RFID
Select Enabled to support Ekahau RFID tag detection,
and then enter the IP address and port number of the
Ekahau Real Time Location System Controller (ERC).
Ekahau RFID
ZoneFlex Indoor Access Point Release 104.0 User Guide
101
Configuration
Configuring the AP
To Next Page
Loading...
