Figure 53: The Configuration > Wireless > Advanced > Common page
2. Configure the advanced settings listed in the following table as required.
Table 43: Advanced common wireless settings
DescriptionOption
The default setting is Full. Select the level
of transmit power from the drop-down
menu. This option sets the maximum
transmit power level relative to the
predefined power (this value differs
according to the current country code).
Transmit Power
(Disabled by default.) If you activate
protection, you control how 802.11
devices know when they should
communicate with another device. This
is important in a mixed environment of
both 802.11b and 802.11g/11n clients.
CAUTION! Activating this option (and
configuring the settings) boosts the
interoperability of 802.11b and
802.11g/11n devices but severely
decreases performance.
CTS-only: Choose this option to force all
destination devices to acknowledge their
ability to receive data when a
transmission is initiated. Use this option
for compliance with the Wi-Fi Alliance
certification. RTS/CTS: Choose this
option to force both sending and
receiving devices to confirm a data
exchange on both ends before
proceeding.
Protection Mode
3. Click Update Settings to save and apply the changes.
ZoneFlex Indoor Access Point Release 104.0 User Guide
103
Configuration
Configuring the AP
To Next Page
Loading...
