Figure 58: Threshold settings
4. Review the options listed in the following table, and then make any needed changes.
Table 47: Threshold options
DescriptionOption
(The default value is 100.) The value
indicates the frequency interval of the
beacon in milliseconds. A beacon is a
broadcast packet sent by the AP to
synchronize the wireless network.
Beacon Interval
(The default value is 1.) The value
indicates the interval of the Delivery Traffic
Indication Message (DTIM). This is a
countdown field that the device uses to
inform its clients of the next window for
listening to broadcast or multicast
messages.
Data Beacon Rate (DTIM)
(The default value is 65535.) This option
determines at what packet length the
RTS/CTS function is triggered. A lower
threshold may be necessary in an
environment with excessive signal noise
or hidden nodes, but may result in some
performance degradation.
RTS/CTS Threshold
5. Click Update Settings to save and apply the changes. A confirmation message
appears at the top of the page.
You have completed configuring the threshold options. To reopen the previous page,
click the Go back to Wireless Configuration link.
Rate Limiting
Rate Limiting allows you to cap the per client data transfer rates for a specific WLAN.
1. Go to Configuration > Wireless or Configuration > Radio 2.4G or Configuration
> Radio 5G.
2. Select the WLAN number that you want to configure from the tabs at the top of the
page.
3. Click the Edit Settings button next to Rate Limiting. The Rate Limiting page
appears.
ZoneFlex Indoor Access Point Release 104.0 User Guide
113
Configuration
Configuring the AP
To Next Page
Loading...
