Figure 42: The Configuration > Radio 5G > Common tab
2. Verify that the common wireless settings are configured as listed in the following
table.
Table 40: Common wireless configuration
Recommended ValueSetting
SmartSelect.Channel
If you purchased the AP in the United States, this
value is fixed to United States at the factory and is
not user configurable. If you purchased the AP
outside the United States, verify that the value is set
to your country or region. Selecting the correct
country code ensures that the AP uses only the radio
channels allowed in your country or region. Note for
dual-band AP users: The two radios on dual-band
APs are always configured with the same country
code setting. If you change the country code for
Radio 1, for example, the same change is
automatically applied to Radio 2.
Country Code
3. If you made any changes to the Common tab, click Update Settings.
4. Continue with "Configuring Wireless # (WLAN number) Settings" below.
Configuring Wireless # (WLAN number) Settings
1. Click one of the Wireless # (WLAN number) tabs.
80
ZoneFlex Indoor Access Point Release 104.0 User Guide
Installation
Step 1: Preconfiguring the AP
To Next Page
Loading...
