• IPv4 Secondary DNS Server: The IP address of the secondary DNS server.
5. Continue with Static IPv6 on page 96, or
6. Click Update Settings to save your changes.
Static IPv6
Configuring a static IPv6 address is optional.
1. In IPv6 Connection Type, select Static IP.
2. When the Internet Connection Settings options appear, you can make changes to
the following settings:
• IPv6 Primary DNS Server: The IP address of the primary Domain Name System
(DNS) server.
• IPv6 Secondary DNS Server: The IP address of the secondary DNS server.
• IPv6 Address: Enter the static IP address that you want to assign to the AP in
IPv6 (colon-separated) format.
• IPv6 Prefix Length: Enter the prefix length for the network.
• IPv6 Gateway: Enter the gateway IP address of the Internet interface.
3. Click Update Settings to save your changes.
Configuring PPPoE
Use the following procedure to configure PPPoE addressing for the AP.
Point to Point Protocol over Ethernet (PPPoE) is a Layer 2 protocol which uses the PPP
(Point to Point) protocol to connect a client system to a server system over a one to one
network link. All traffic for a PPPoE connected client must go through the PPPoE server
to reach the client. A PPPoE server can therefore be used to route, NAT, firewall, and
perform QoS traffic shaping.
If a PPPoE server is used to distribute Internet access to subscribers, the AP can be
configured with a PPPoE username and password to authenticate with the PPPoE server.
PPPoE is available only for the IPv4 connection type; PPPoE is not supported in IPv6
environments.
1. Go to Configuration > Internet.
2. Under IPv4 Connection Type select PPPoE.
3. Enter a PPPoE Username.
4. Enter a PPPoE Password.
5. Retype the password in PPPoE Password Confirmation.
6. To allow the DNS mode to be determined automatically, set IPV4 DNS Mode to
Auto.
7. To set the DNS mode manually, set IPV4 DNS Mode to Manual. Then enter the
following:
96
ZoneFlex Indoor Access Point Release 104.0 User Guide
Configuration
Configuring the AP
To Next Page
Loading...
