Web-based Configuration Guide Networks Settings
73
3.26.3 Configuring PPTP Client
Note
This feature is not supported on RG-EW300 PRO and RG-EW1200 routers.
Choose More > Switch to PC view-> More-> VPN-> PPTP.
PC View: Choose More-> VPN-> PPTP.
Click Enable to enable the PPTP function. Select Client and enter the username and password configured on
the server, which must be consistent with the server configuration.
Tunnel IP: It is the virtual IP address used to create the VPN tunnel. You are advised to select Dynamic to
obtain the IP address assigned by the server. You can also set static IP addresses in the address pool that does
not cause conflicts.
Server Address: Enter the WAN port IP address (the public IP is required) or the domain name of the server.
Peer Subnet: Enter the target network segment of the server, which cannot be the same as that of the client.
Work Mode: The NAT mode only allows the client to access the Internet on the server and does not allow the
server to access the Internet on the client. The Router mode allows the server to access the Internet on the
client.
PPP Hello Interval: Enter the interval for sending hello packets. You are advised to set the value to 10.
Click Save and the device will send the VPN tunnel request to the WAN port.
To Next Page
Loading...
Need help?
General
