Web-based Configuration Guide Configuring the Repeater Mode
80
4 Configuring the Repeater Mode
4.1 Access Point
The access point mode relies on an Ethernet cable to provide reliable transmission over a more stable Wi-Fi
network with less interference. You are advised to use the access point mode. Ensure that the primary router
can access the Internet with DHCP server enabled. Otherwise, the configuration will fail.
Mobile Phone View: Choose More > Switch to PC view > More > Work Mode
PC View: More >Work Mode
Click Access Point, click Check, and then click Save. The device will run in the AP mode, namely, network
address translation (NAT) and DHCP-related routing functions will be disabled.
Caution
Ensure that the primary router can access the Internet with DHCP server enabled. After the configuration is
saved, the Wi-Fi network will be restarted, and clients need to reconnect to the Wi-Fi network.
Figure 4-1 Access Point Settings
To Next Page
Loading...
Need help?
General
