106 CompTrol Interface V4.0.x | Issue 21-05-2021 | 1000932
Error codes
19.1 Rebooting the system
Procedure
1. Switch o power to the CompTrol Interface by removing the connector from terminal X1 or X5
(see “4.2 CompTrol Interface electrical supply” on page 18) of the CompTrol Interface.
2. Re-insert the connector into the terminal.
3. Connect the CompTrol Interface to the electrical supply and wait for it to initialize.
If the error recurs frequently, check the bus cable to the indoor unit.
20 Disposal
Do not dispose of the CompTrol Interface expansion module with household garbage.
Always dispose of electronic equipment at local collection points for waste electronic
equipment, in accordance with the Waste Electrical and Electronic Equipment Directive!
To Next Page
Loading...