S-Klima CompTrol - Appendix II: Start-Up Report

CompTrol Interface V4.0.x | Issue 21-05-2021 | 1000932 113
Appendix II: Start-up Report
27 Appendix II: Start-up Report
KTR number: Order: Specialist operator/fitter
Model/type:
Check installation (check box as applicable)
Checked
Interface mounted on DIN rail in switch gear cabinet and checked for secure mounting Yes No
Secure fastening of cables in screw terminals checked Yes No
Check electrical supply (check box as applicable)
Checked
External electrical supply at input X5 connected and checked *
Yes No
Jumpers at pin headers S5 and S6 inserted and checked
Yes No
* Necessary in combination with CompTrol Interface Master.
Check connections (check box as applicable)
Checked
Remote control bus (X/Y bus) at input X1 connected and checked
Yes No
Total length of remote control bus checked
_____
m (max. 120 m) Yes No
Analog signal at analog inputs X3-S and X3-(-RV) connected
Yes No
Polarity at analog inputs X3-S and X3-(-RV) checked
Yes No
Digital output X4a-I for status signal connected and checked *
Yes No
Digital output X4b-II for status signal connected and checked *
Yes No
Digital output X4c-III for status signal connected and checked *
Yes No
Digital inputs X2a-D1 and -D2, X2b-D3 to X2b-D5, X2c-D6, X2N-N connected and checked
Yes No
Correct wiring checked Yes No
*
Status signal is dependent on the set program.
For a description of programs, see the CompTrol Interface V4.0.x Technical Manual.
Set analog signal at analog input X3
0-20 mA set at pin headers S4 and S7
4-20 mA set at pin headers S4 and S7
NOTES
- Comply with the safety instructions and technical data in the
CompTrol Interface V4.0.x Technical Manual.
- All work must be performed exclusively by authorized and
trained specialist personnel.
CompTrol Interface V4.0.x Start-up Report
S4
S7
0-10 V DC set at pin headers S4 and S7
0-5 V DC set at pin headers S4 and S7