14 CompTrol Interface V4.0.x | Issue 21-05-2021 | 1000932
Safety
●
S series Technical Manual
●
SX series Technical Manual
●
CompTrol Signal DC Technical Manual
●
Construction Site Technical Manual: Quick guide for the construction site
2.6 Transport and storage
Check the delivery immediately on receipt for completeness and transport damage. Notify your
specialist retailer of any transport damage immediately. Do not install or operate the unit if there is
evidence of transport damage which may jeopardize the unit's operational reliability.
The unit is packaged in a cardboard box. Open the box carefully to prevent damage to the surface
of the unit.
If the unit is to be placed in interim storage after delivery, take the following precautions for protec-
tion against corrosion and damage:
●
Store the unit in a dry location.
●
Store the unit in its packaging if possible.
Dispose of the packaging responsibly. To avoid the risk of asphyxiation, keep plastic packaging
out of reach of children and dispose of it after opening.
2.7 Installation
When installing the unit, always pay attention to the notes on installation
(see “17 Installing the CompTrol Interface expansion module” on page 95) and the power
source specications (see “21 Technical data” on page 107).
The electrical installation and wiring must comply with the applicable local regulations, the
specications of the VDE (German Association for Electrical, Electronic & Information
Technologies), and the local mains grid operator.
2.8 Spare parts
We recommend the use of original spare parts. Original spare parts and spare parts/accessories
approved by Stulz GmbH are a guarantee of safety.
The spare parts list can be found in section “23 Spare parts” on page 109. To order spare parts,
call your specialist retailer.
To Next Page
Loading...