Change Admin User Password
With software versions later than 7.3.100, the Admin user account default password must
be changed before IntelliLink Setup Software can connect to a control.
Follow these steps to change the Admin user password:
STEP 1. After IntelliLink Setup Software is launched and the default Admin password
is used to connect to a control, the prompt shown in Figure 103 opens to instruct
the user to change the Admin user account password.
Figure 103. The Password Change Required dialog box.
STEP 2. Enter a new non-default password meeting the complexity requirements into
the Enter Password and the Conrm Password elds. Then, click on the
OK button. See Figure 104.
Figure 104. The Change Password dialog box.
170 S&C Instruction Sheet 766-530
Security
To Next Page
Loading...
