20 S&C Instruction Sheet 461-509
After allowing approximately 3 minutes for the gateway to boot, a confirmation the
PC has successfully joined the communications gateway network may be observed by
launching an MSDOS command window and running ‘ipconfig /all’ at the command
prompt. An output showing all the IP interfaces for the host system will be displayed.
Identify the Ethernet interface that has the cabled connection to communications gateway
Ethernet Port 1 and examine the output for that interface. Screen information for the
interface supporting a successful connection when using DHCP will resemble what’s
shown in Figure 10.
Figure 10. A successful ipconfig/all reply from the Command prompt.
Conguring the Communications Gateway
To Next Page
Loading...
