S&C Instruction Sheet 461-509 21
Conguring the Communications Gateway
Note: If the interface indicates “media disconnected,” this is an indication the Ethernet
connection between the host PC and the communications gateway is not functional,
and it should be investigated.
NOTICE
Because the end user can change the IP address range, or even disable DHCP
completely and change the communications gateway to a static IP address, it is
important to make a note of any IP settings changes. When relocating or setting
up a communications gateway that has had its IP settings changed, look for the IP
setting configured by your service or IT department when running ipconfig/all from
the MSDOS command line.
With the CAT5 Ethernet cable attached to communications gateway’s Ethernet
Port 1, launch a Web browser on the PC. Type 192.168.1.1 in the browser’s address line.
(Browsers supported include Google Chrome, Internet Explorer, and Microsoft Edge.)
The Communications Gateway Login screen will open with a username and password
challenge. See Figure 11.
Note: The default username and password can be requested from S&C by calling the
Global Support and Monitoring Center at 888-762-1100 or by contacting S&C through the
S&C Customer Portal at sandc.com/en/support/sc-customer-portal/.
Figure 11. The Communications Gateway Login screen.
To Next Page
Loading...
