S&C TripSaver II - Software Operating Modes; Standalone Mode

22 S&C Instruction Sheet 461-509
When logging in for the first time, users will be sent to the Profile screen and be
prompted to change the default password.
NOTICE
With communications gateway firmware version 3.1 and later, the default password
for the admin user must be changed before proceeding. See Figure 12. The new
non-default password must be at least 8 characters with at least one uppercase
and one lowercase character. Numbers and special characters are also allowed
but not required. <Space>, <Tab>, <&> characters are not allowed. Do not lose this
password. There is no way to recover a lost password in the field. A lost password
will require returning the gateway controller module to S&C for re-initialization.
Figure 12. The Profile screen for changing the default password.
After a successful login, the browser will open to the communications gateway
General Status screen with an application navigation menu on the left side of the screen.
The navigation menu will remain visible for all subordinate menu interface screens. See
Figure 13 on page 23.
NOTICE
Simultaneous access to the web user interface by multiple users is not officially
supported. If it is desired to have multiple users logged in simultaneously, it is
strongly recommended that only one of those users be assigned the admin role. It
is also strongly recommended that only one of those users modify settings on the
gateway. The other users should be performing read-only activities. Also, if two
users are sharing a single username and the users attempt to log in at the same
time, the older session will be silently logged out.
Conguring the Communications Gateway