S&C TripSaver II - Page 26

26 S&C Instruction Sheet 461-509
The fields required within this panel are determined by the DHCP button toggled to
the On or Off positions. With DHCP in the Off position, management devices connected
to communications gateway’s physical Port 1 must be configured with a static IP address
that resides in the communications gateway’s LAN IP range identified by the NetMask
setting in the previous field.
With DHCP in the On position, management devices connected to communications
gateway’s physical Port 1 will be assigned an IP address from the specified IP range
determined by the DHCP Server Start IP Address and DHCP Server End IP Address
fields. Also included is a Ping Response toggle button. Toggling this button to the On
position will make the gateway responsive to a ping command. This toggle button is in
the Off position by default. See Figure 16.
Figure 16. The Ethernet 1 (LAN) fields with DHCP set in the On position.
Conguring the Communications Gateway