S&C TripSaver II - Page 63

S&C Instruction Sheet 461-509 63
Conguring the Communications Gateway
Follow these steps to input the settings:
STEP 1. Navigate to the eld on the Status Point line.
STEP 2. Initiate the drop-down menu by selecting the eld.
STEP 3. Highlight the desired identier.
STEP 4. Select the check mark for acknowledgement.
STEP 5. After all points are mapped, click on the Save button at the top of the screen.
Figure 61 shows an example of Status Point 1 after being saved to the
communications gateway.
Figure 61. A completed Status Point entry.