SATO PW208NX - Page 103

100
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
Head Interval
System > Notications > Clean Head > Head Interval
Set the notication interval about when the print head needs to be cleaned.
When the print distance after the counter is reset reaches to the set value, a status
icon for notications is displayed.
You can change settings only if you have selected Enabled in the Clean Head >
Clean Head.
Initial value : 150 m
Setting range : 10 to 1000 m
Note
For details on notications, see “3.4 Notications” (

page 139).
Change Head
System > Notications > Change Head
To notify when the print head needs to be replaced, the setting items are as follows:
1 Change Head Enable or disable the notication function about when the
print head needs to be replaced.
2 Head Interval Set the notication interval about when the print head
needs to be replaced.
You can change settings only if you have selected
Enabled in the Change Platen > Change Platen.
3 Head Counter Shows the current print distance.
You cannot change the setting.
Change Head
System > Notications > Change Head > Change Head
Enable or disable the notication function about when the print head needs to be
replaced.
Initial setting : Disabled
Setting options : Enabled, Disabled
Enabled : Enable the notication function.
Disabled : Disable the notication function.