SATO PW208NX - Page 104

Starting Up the Printer
101
Mobile printer PW208NX/PW208mNX
Head Interval
System > Notications > Change Head > Head Interval
Set the notication interval about when the print head needs to be replaced.
When the print distance after the counter is reset reaches to the set value, a status
icon for notications is displayed.
You can change settings only if you have selected Enabled in the Clean Head >
Clean Head.
Initial value : 30 km
Setting range : 1 to 30 km
Note
For details on notications, see “3.4 Notications” (

page 139).
Change Platen
System > Notications > Change Platen
To notify when the platen roller needs to be replaced, the setting items are as follows:
1 Change
Platen
Enable or disable the notication function about when the
platen roller needs to be replaced.
2 Platen
Interval
Set the notication interval about when the platen roller needs
to be replaced.
You can change settings only if you have selected Enabled in
the Change Platen > Change Platen.
3 Platen
Counter
Shows the current distance the platen roller has fed.
You cannot change the setting.
Change Platen
System > Notications > Change Platen> Change Platen
Enable or disable the notication function about when the platen roller needs to be
replaced.
Initial setting : Disabled
Setting options : Enabled, Disabled
Enabled : Enable the notication function.
Disabled : Disable the notication function.