SATO PW208NX - Page 89

86
Mobile printer PW208NX/PW208mNX
Starting Up the Printer
PSW
Interface > Bluetooth > PSW
Set the PSW communication parameter when Enable is set to Enabled.
Set to a value that is lower than the PSI communication parameter setting.
Setting range varies depending on the PSI communication parameter setting value.
Initial value : 18
Setting range : 17 to 144
Give BD Address
Interface > Bluetooth > Give BD Address
When this function is enabled, BD address is added to the printer device name.
Initial value : Enabled
Setting options : Enabled, Disabled
Example (When BD address is XXXXXXXXXX)
Enabled : SATO_PRINTER_XXXXXXXXXX
Disabled : SATO_PRINTER
IO Compatible
Interface > Bluetooth > IO Compatible
Set the authentication process in Secure Simple Pairing.
Initial setting : Disabled
Setting options : Enabled, Disabled
Enabled : The pass key is not displayed in Secure Simple Pairing.
Disabled : The pass key is displayed in Secure Simple Pairing.
CRC Mode
Interface > Bluetooth > CRC Mode
Enable or disable the functions for CRC when Enable is set to Enabled.
Initial setting : Disabled
Setting options : Enabled, Disabled
Enabled : Enable the CRC function.
Disabled : Disable the CRC function.
Flow Control
Interface >Bluetooth > Flow Control
Set the communication protocol when Enable is set to Enabled.
Initial setting : Status4
Setting options : Status3, Status4, None