Scaime eNod4-B - Page 5

5/95
User manual SCAIME: NU-soft-eNod4B-E-0716_236704-C.doc
10.3.26 Start (batch/system) ......................................................................... 53
10.3.27 Stop (batch/system) ......................................................................... 53
10.3.28 Clear totalization & errors counter ................................................... 53
10.3.29 Calibration of flow rate ..................................................................... 54
10.3.30 PID parameters auto-adjustment .................................................... 54
10.3.31 STOP & RESTART PID ........................................................................... 54
10.3.32 Clear great total ................................................................................ 54
10.3.33 Clear general total ............................................................................ 54
11 CALIBRATION SETTINGS AND PROCEDURES ..................................................... 55
11.1 Principles ..................................................................................................... 55
11.2 Calibration methods .................................................................................. 56
11.3 Settings description .................................................................................... 56
11.3.1 Maximum capacity ............................................................................ 56
11.3.2 Number of calibration segments ....................................................... 56
11.3.3 Calibration loads 1/2/3 ...................................................................... 56
11.3.4 Sensor sensitivity .................................................................................. 56
11.3.5 Scale interval ....................................................................................... 56
11.3.6 Zero calibration ................................................................................... 57
11.3.7 Span coefficients 1/2/3 ...................................................................... 57
11.3.8 Span adjusting coefficient ................................................................. 57
11.3.9 Calibration place g value / place of use g value ........................... 57
11.3.10 Zero offset........................................................................................... 57
12 FILTERS ................................................................................................................. 58
12.1 Principles ..................................................................................................... 58
12.2 Settings list ................................................................................................... 58
12.3 Settings description .................................................................................... 58
12.3.1 A/D conversion rate ............................................................................ 58
12.3.2 Filters activation & order ..................................................................... 59
12.3.3 Low-pass filter cut-off frequency ....................................................... 59
12.3.4 Limitations ............................................................................................ 60
12.3.5 Band-stop filter high cut-off frequency ............................................. 60
12.3.6 Band-stop filter low cut-off frequency .............................................. 60
12.3.7 Moving average weight filter depth .................................................. 60
12.3.8 Moving average flow rate/speed filter depth .................................. 60
13 CONFIGURATION OF INPUT/OUTPUT ................................................................. 61
13.1 Principles ..................................................................................................... 61
13.1.1 Logical inputs....................................................................................... 61
13.1.2 Analog output (IO+ version) .............................................................. 63
13.1.3 Logical outputs .................................................................................... 66
13.2 Settings description .................................................................................... 68
13.2.1 Logical inputs assignment .................................................................. 68
13.2.2 Holding time (debounced time) ........................................................ 69
13.2.3 Analog output(s) assignment (IO+ version) ..................................... 70
13.2.4 External value to control analog output (IO+ version) .................... 70
13.2.5 Logical outputs 1&2 assignment ........................................................ 71
13.2.6 Logical outputs 3&4 assignment ........................................................ 72
13.2.7 Weight quantity per pulse on logical output .................................... 72
13.2.8 Set points functioning ......................................................................... 73