Instructions for Use
Resting & Stress ECG with seca
ct330/331 and seca diagnostic 5.9
The necessary steps for recording and analysing ECG
data in seca diagnostic are shown without a surgery IT system or HIS
connection
→ Apply the ECG device to the patient.
→ Observe the correct sequence of work steps.
Starting the program, calling up stress ECG
→ Start seca diagnostic and log in.
→ Click on Examination, Stress ECG, New Stress ECG.
Selecting a patient
→ Select a patient for the examination. Enter the patient's name into
the input fields in the search mask.
→ Select the patient from the list.
→ Confirm the selection with Select Patient. The patient can also be
selected by double-clicking on the name.
Creating a new patient
→ If the patient does not yet exist in your database:
Click on New Patient.
→ Enter the patient data. The fields marked with an asterisk are
mandatory.
→ Save the data.
→ The patient is entered into the database.
Tip for entries in the patient
menu: Press the tab key to
move the cursor to the next
input field.
To Next Page
Loading...
