Sega Project DIVA Arcade Future Tone - Handling Precautions

HANDLING PRECAUTIONS
3
2
HANDLING PRECAUTIONS
● Proceed with checks and tasks as indicated in these instructions. If instructions
are not followed, or if tasks and/or checks are neglected, an electric shock or
other very serious accident, even fatal accident, can occur. Also, customers
could be injured while operating the product.
● Before starting work, be sure to turn the power off. Working without turning
the power off can cause an electric shock, short circuit or re. In the case work
should be performed in the status of power on, this manual always states to
that effect.
● To avoid an electric shock or short circuit, do not plug in or unplug quickly.
● To avoid an electric shock, do not plug in or unplug with a wet hand.
● Do not leave power cable, earth cables, or network cables exposed in areas
of heavy foot trafc. Doing so may cause them to become damaged, possibly
resulting in electric shock and/or short circuits. When laying wiring across the
oor, always use safety covers to protect the cables.
● To avoid causing a re or an electric shock, do not put things on or damage the
power cables.
● When or after installing the product, do not unnecessarily pull the power cable.
If damaged, the power cable can cause an electric shock, short circuit or re.
● In case the power cable is damaged, ask for a replacement through the ofce
listed in this manual or the point-of-purchase for this product. Using the cable
as is damaged can cause re, an electric shock or leakage.
● Be sure to perform grounding appropriately. Inappropriate grounding can cause
an electric shock.
● When inserting or removing a connector, be sure to hold it by its main part. If
you hold it by anything else while doing so, the connections between cable and
connector terminal xtures could be damaged; and there could be an electric
shock, short circuit or re. There could also be poor connectivity.
● Be careful with the direction when connecting connectors. The connector must
be connected in the proper direction. If it is connected in the wrong direction
or indiscriminately at an incline so that a load is applied, the connector or its
terminal pins could break, causing an electric shock, short circuit or re.
● Be careful not to damage the cables. Damaged cables may cause an electric
shock, short circuit or re.
● Do not twist or pull the wiring. Damaged wiring may cause breakdowns or res.
● Do not touch undesignated places. Touching places not designated can cause
an electric shock, short circuit or re.
● Be careful not to lose any fasteners (screws, nuts, or washers) during work. A
metallic fastener dropped on an electried section may cause an electric shock,
short circuit or re.
2
http://op.sega.jp/op_e/