Sega Project DIVA Arcade Future Tone - Limitations of Usage

8
PRECAUTIONS REGARDING INSTALLATION LOCATION
3-1 LIMITATIONS OF USAGE
● Be sure to check the electrical specifications. Ensure that this product
is compatible with the location's power supply, voltage, and frequency
requirements. A plate describing electrical specifications is attached to the
product. Noncompliance with the electrical specications can cause an electric
shock or re.
● This product requires a breaker and earth mechanism as part of the location
facilities. Using the product without these can cause a re and electric shock.
● Be sure to use an independent power supply equipped with an earth leakage
breaker. Use of power supply without such a breaker could result in re if there
is a current leakage.
● Putting many loads on one electrical outlet can cause generation of heat and a
re resulting from overload.
● Make sure the interior wiring used to power the product has the following
capacitance. Noncompliance with the electrical specifications can cause an
electric shock and re.
- AC 100 V - 120 V: 10 A or higher
- AC 220 V - 240 V: 5 A or higher
● When using an extension cable, use a cable that meets at least the ratings
listed below. Using a cable rated lower than the specied rating can cause a re
and electric shock.
- AC 100 V - 120 V: 10 A or higher
- AC 220 V - 240 V: 5 A or higher
ELECTRICITY CONSUMPTION (MAX.)
2.72 A Single phase AC 100 V, 50/60 Hz Area
2.6 A Single phase AC 110 V, 60 Hz Area
2.3 A Single phase AC 120 V, 60 Hz Area
1.2 A Single phase AC 220 V, 50/60 Hz Area
3
http://op.sega.jp/op_e/