TOUCH SLIDER
63
11
TOUCH SLIDER
● This work should be performed by site maintenance personnel or other
qualied professionals. Work performed by non-technical personnel can cause
a severe accident such as an electric shock.
● Before starting work, be sure to turn the power off. Working without turning the
power off can cause an electric shock, short circuit or re.
● Be careful not to damage the cables. Damaged cables may cause an electric
shock, short circuit or re.
● Be careful not to lose any fasteners (screws, nuts, or washers) during work. A
metallic fastener dropped on an electried section may cause an electric shock,
short circuit or re.
● When opening/closing or attaching/removing doors or other parts, be careful
that your hands or ngers do not get caught in anything.
● If all afxed fasteners (screws, nuts, and washers) are removed, parts will fall
off and cause accidents. Ensure that parts are rmly supported when removing
afxed fasteners.
● Be careful in handling plastic parts. If such parts are exposed to excessive
loads or impact, they might become damaged, resulting in fragments or cracks
that could cause accidental injury.
● When fastening plastic parts, be careful not to tighten screws and nuts
excessively. Failure to observe this may damage the parts and cause injury due
to fragments resulting from damage.
● Take care when handling parts inside the control panel. Ensure that no damage,
warping, or loss occurs. Missing parts may result in accidents leading to
damage or malfunction.
11
To Next Page
Loading...
