44
ASSEMBLY AND INSTALLATION
6-7 SOFTWARE INSTALLATION
● The following explanation assumes that the product has been assembled
properly as explained above. If there is an error or if the product operates in a
manner other than as indicated below, cut off the power supply immediately.
Failure to do so may result in a re or electric shock.
● If you look directly at the laser beam in the DVD drive, you could suffer vision
impairment. Do not look inside the DVD drive.
Do not start any other work until the installation work is complete.
CAUTIONS REGARDING USE OF DVD DRIVE KIT
● Do not use or store the DVD drive kit in any of the following locations, as this may
result in serious damage.
[Do not use or store in these locations.]
- Anywhere which may vibrate or shock the equipment
- In direct sunlight
- In damp or dusty places
- In places with a sharp change in temperature
- Close to anything that gives off heat (a heater, etc.)
- Close to anything with a strong magnetic eld (magnets, monitor, speakers,
radio, etc.)
- Anywhere that is likely to get wet (kitchen, etc.)
- Anywhere with a slope or incline
- Anywhere with corrosive gas in the air (chlorine, hydrogen sulde, ammonia,
sulfur dioxide, etc.)
- Anywhere with strong static electricity
[Do not use in these locations.]
- Close to anything that is highly retentive of heat (carpet, sponge, cardboard, etc.)
- Anywhere that blocks the DVD drive air vent
There is no need to work the following procedure if the software has been installed.
Proceed to "Chapter 7 SET UP."
6
To Next Page
Loading...
