11
INSTALLATION
6
INSTALLATION
6
To install the unit, follow these instructions in this manual carefully. If the unit is not
installed properly, it may cause personal injury or damage to the machine.
Carry out the following five steps to assemble and install the product.
For assembly and installation, you need a Philips screwdriver, adjustable wrench (for 24mm hexagonal
bolts) and the operator’s key.
OPERATOR’S KEY
PHILIPS SCREWDRIVER
(For M4 screws)
WRENCH (for M16 HEXAGONAL BOLTS)
6-1 SECURE THE UNIT AT THE INSTALLATION SITE (MANIPULATE THE ADJUSTERS)
6-2 REMOVE SHIPPING BRACKETS
6-3 ATTACH PARTITION
6-4 CONNECT POWER CORD
6-5 ACTIVATE POWER SUPPLY
24 mm
To Next Page
Loading...
Need help?
General
