26
EXPLANATION OF TEST AND DATA DISPLAY
11
- Service Button: Separated for 1P and 2P. Used when increasing the number of credits for
service without tabulating the coin meter. If this button is pressed when an error
has occurred, the error sound stops. If it is pressed in test mode, credits are
cleared.
- Sound Volume: Adjusts the game music volume. Set for a suitable volume in consideration of the
surrounding environment.
- Meter: Count content set with DIP SW2 is displayed on meter 1 and meter 2.
- Coin Meter: Separated for 1P and 2P. Counts the number of coins inserted in the coin slot.
- Sub Power Supply Switch: This is a power supply switch. The main switch is located on the AC unit on the
cabinet rear panel. There is power when both switches are ON.
Open the cash box door to find the cash box inside.
11-2 VFD DISPLAY CONTENT
Normally, the POWER setting screen is displayed.
When the select button is pressed, the current credit status can be displayed on VFD.
Each time the select button is pressed, the screen changes.
If there are no operations for 60 seconds, the POWER setting screen is restored.
When the select button is kept depressed for 2 seconds or longer, [Current count] and [Total count] can be toggled.
In [Current count], upon switching to [Service count since last clearing], the screen will return to [Income since last
clearing].
In [Total count], upon switching to [Backup clear], the screen will return to [Total income count].
To clear data, enter test mode. Press the clear button when [CLEAR?] is displayed, and the data can be cleared.
In [Current count], it is possible to clear the data but the data cannot be cleared without being in test mode (The clear
screen will not be displayed).
In [Total count], backup data cannot be cleared without both 1P and 2P being in test mode (The clear screen will not
be displayed).
The data backup period lasts for two days after power has been cut off.
PHOTO 11-1
To Next Page
Loading...
