57
PERIODIC INSPECTION
17
PERIODIC INSPECTION17
The items listed below require periodic check and maintenance to retain the performance of this machine and to
ensure safe business operation.
ITEMS DESCRIPTION PERIOD REFERENCE
CABINET
Check that adjustors in contact with
floor
Daily See Section 3
GEAR COMPONENTS Apply Grease 3 months See Section 13
FLUORESCENT LIGHTING
Inspection of Lighting Equipment As necessary See Section 16
COIN SELECTOR
Coin Insertion Test
Monthly See Section 15
Cleaning Tri-monthly See Section 15
GLASS DOOR Cleaning As necessary See below.
CABINET SURFACES
Cleaning As necessary See below.
ELECTRICAL/ELECTRONIC COMPONENTS
Inspection As necessary See above.
INTERIOR Cleaning Annually See above.
POWER SUPPLY PLUG
Inspection and Cleaning Annually See above.
TABLE 17 PERIODIC INSPECTION TABLE
When the cabinet surfaces become dirty, remove stains with a soft cloth soaked in water or diluted (with water)
chemical detergent and then wrung dry. To avoid damaging the finish, do not use such solvents as thinner, benzene,
etc. (other than ethyl alcohol) or abrasives (bleaching agent and chemical dust-cloth).
Some general-purpose household, kitchen, and furniture cleaning products may contain strong solvents that degrade
plastic components, coatings, and print. Before using any cleaning product, read the product's cautionary notes
carefully and test the product first on a small area that is not highly visible.
Cleaning the Glass Door
The glass door can easily become dirty so be sure to clean it often. Use regular glass cleaners and wipe both glass
surfaces. If you are using a spray glass cleaner, be sure to wipe away cleaner left on surrounding non-glass areas.
• Be sure to check once a year to see whether Power Cords are damaged, the
plug is securely inserted, dust has accumulated between the Socket Outlet and
the Power Plug, etc. Using the product with accumulated dust can cause fire
and electric shock.
• Never use a water jet, etc. to clean inside and outside the cabinet. If the
machine gets wet for any reason, do not use it until it has completely dried.
• Periodically, around once a year, get in touch with the place of contact herein
stated or the Distributor, etc. where the product was purchased from, regarding
internal cleaning. Using the product with accumulated dust in the interior can
cause a fire or accident. Note that professional cleaning will require a fee.
• There is the danger of accidents involving electrical shorts circuits or fire caused
by factors such as the deterioration of insulation in electrical and electronic
equipment over time. Check that there are no anomalies such as odors from
burning.
Cleaning the Cabinet Surfaces
To Next Page
Loading...
