53
REPLACEMENT OF FLUORESCENT LIGHTING, LAMPS, AND FUSES
16
1. Turn the power off.
2. Loosen the two screws and remove the switch cover. Hold the switch cover (L) while removing so it will not fall.
16-2 LAMP REPLACEMENT
Replacement of Down Button Lamp
The provided tamperproof wrench is required for the following procedures.
1. Turn the power off.
PHOTO
16-2a
2. Remove the 7 tamperproof screws, then remove the
control panel.
• Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of fire.
• When fixing the plastic parts, do not fasten the screws and nuts too tightly.
Failure to observe this instruction may damage these parts and as a result the
broken pieces of these parts may cause a person injury.
3. Remove fluorescent lamps by pushing them upward and replace. (See FIG. 16-1.)
SCREW (2)
M4 x 8, w/flat & spring washers
SWITCH COVER (L)
[Opposite side: SWITCH COVER (R)]
To Next Page
Loading...
