59
TROUBLESHOOTING
19
TROUBLESHOOTING19
The items listed below require periodic check and maintenance to retain the performance of this machine and to
ensure safe business operation.
CIRCUIT PROTECTOR
FIG. 19b
The Circuit Protector uses a bimetal to break the circuit.
Due to the heat, the machine cannot be restarted until it
cools. Wait at least 1 minute before restarting. (Press the
button in.)
• In order to prevent electric shock and short circuit, be sure to turn the power off
and unplug the electrical cord from the outlet before working on the machine.
• Be careful not to damage wiring. Damaged wiring may cause electric shock or
short circuit.
• After fixing the problems regarding the Circuit Protector, reinstate the Circuit
Protector. Depending on the cause of the problem, using the Circuit Protector
without addressing the malfunction can generate heat and can present a fire
hazard.
FIG. 19a
YES
OFF
NG
OFF
NO
Problem has occurred.
Dose the fluorescent
lighting turn on?
Is the fuse okay?
Is the machine in
display mode?
Is there an error
displayed?
Can a game be played?
Is the POWER LED
on the GAME BD lit?
Go to error correction.
Go to fuse replacement.
Check DIP SW.
Are LEDs 1 and 2
on the GAME BD lit?
No power is going
to the GAME BD.
Turn off power supply SW.
There could be defective
wiring or disconnection.
The GAME BD is
operating.
The GAME BD is
not operating
properly.
Are the glass doors
closed?
Are the power supply
switches ON?
Is the circuit
protector ON?
Check the power cord.
AC 120V is not
being supplied.
Either the wiring is
defective or the flourescent
light has burnt out.
Close the glass doors on
the left and right securely.
Turn the power supply
switches in both
locations to ON.
Turn the protector to
ON. (See Fig.6-4a)
Insert cord into
outlet/inlet properly.
Flashing or out.
YES
NG
YES
YES
NO
YES
NO
GOOD
NO
NO
NO
YES
ON
ON
GOOD
YES
To Next Page
Loading...
