Sega UFO CATCHER - Removing Shipping Brackets

13
INSTALLATION
6
6-2 REMOVE SHIPPING BRACKETS
• Hold the parts to be removed firmly and then remove the screws that hold
them in place. If parts are not held firmly, they may fall and cause an accident.
• Do not move the UFO mechanism while holding onto parts not described in the
procedures. You may get your fingers, etc., caught and be injured.
• The mechanism is secured in place for shipment so it will not be damaged during
transport. Before activating the power supply, be sure to remove the shipping
brackets used to secure the mechanism. If they are not removed, parts may get
damaged.
• Shipping brackets are required for preventing damage during transport. Be sure to
store them carefully.
1. Open the glass door with the operator’s key.
2. Remove the screw in the shipping bracket mechanism.
PHOTO 6-2a
PHOTO 6-2
b
IMPORTANT
Unlock and open glass door.
(The opposite side can be opened in similar fashion)
SHIPPING BRACKET MECHANISM
M4 x 8, w/flat & spring washers
Z MECHANISM
SCREW (1)