46
ARM MECHANISM
13
13-5 OPEN ARM ANGLE ADJUSTMENT
In cases such as when the arm comes in contact with the UFO cover, the open arm angle should be adjusted. For the
following procedures, an M3 Philips screwdriver or a screwdriver/spanner for M3 hexagonal nuts is required.
PHOTO
13-5a
PHOTO
13-5b
1. Loosen the two screws. Hold the arm mechanism at
this time so it will not fall.
2. Remove the arm mechanism.
Be especially careful when removing, as there are
connections.
PHOTO
13-5c
3. Loosen the two flange nuts.
5. Tighten the flange nuts and follow the above procedure in reverse order to attach the arm mechanism.
Be sure to confirm at this time that no wiring has been caught.
PHOTO
13-5d
4. Slide the sensor bracket arm laterally to adjust the
open arm angle.
When the arm is slid to side A, the open arm angle
becomes large. When the arm is slid to side B, the
angle becomes small.
To Next Page
Loading...
