Sega UFO CATCHER - Test Mode and Data Display Explanation; Switch Unit and Cash Box Components

25
EXPLANATION OF TEST AND DATA DISPLAY
11
EXPLANATION OF TEST AND DATA DISPLAY11
11-1 SWITCH UNIT AND CASH BOX
Do not touch any areas other than those indicated. Touching other areas may
cause accidents from electrical shocks or short circuits.
When you open the service door at the bottom of the cabinet front panel, you will find a switch unit deep inside.
The functions of each button on the switch unit are as described below.
- VFD Display: Monitor for displaying conditions such as income data.
- 1P Power Knob: Adjusts the strength of the 1P UFO mechanism spring.
Adjustment ranges from 00 (weakest) to 99 (strongest).
- 2P Power Knob: Adjusts the strength of the 2P UFO mechanism spring.
Adjustment ranges from 00 (weakest) to 99 (strongest).
- Select Button: Used when switching VFD display content.
- Clear Button: Used when clearing data displayed on VFD.
- Test Button: Separated for 1P and 2P. Used when entering the test mode and when
completing the test mode.
FIG. 11-1
If the coin meter circuit is left detached, games cannot be played.
IMPORTANT
1P POWER KNOB (1P POWER)
1P SERVICE BUTTON (SERVICE)
2P POWER KNOB (2P POWER)
SOUND VOLUME (VOL)
DIP SW 1 DIP SW 4 (See Section 12.
)
METER 1 (METER 1)
CLEAR BUTTON (CLEAR)
SELECT BUTTON (SELECT)
2P SERVICE BUTTON (SERVICE)
2P TEST BUTTON (TEST)
1P TEST BUTTON (TEST)
METER 2 (METER 2)
SUB POWER SUPPLY SWITCH
(SUB SW)
COIN METER 1P (COIN METER 1P) COIN METER 2P (COIN METER 2P)
VFD DISPLAY
STICKER DIP SW