2
1
HANDLING PRECAUTIONSAS
• For the IC board circuit inspections, only the logic tester is allowed. The use of a
multiple-purpose tester is not permitted, so be careful in this regard.
• Static electricity from your body may damage some electronics devices on the
IC board. Before handling the IC board, touch a grounded metallic surface so
that the static electricity can be discharged.
• Some parts are the ones designed and manufactured not specifically for
this game machine. The manufacturers may discontinue, or change the
specifications of, such general-purpose parts. If this is the case, Sega cannot
repair or replace a failed game machine whether or not a warranty period has
expired.
• This game machine can be installed at a storefront but could tip over due to
sudden strong drafts or building winds. It could also tip over from man-made
loads. If the game machine does fall down, a serious accident could result. To
prevent the machine from falling down, carry out the following procedures and
make every effort to operate the machine safely.
-
Never place the product at a site that is inclined or has level differences.
If there are inclines or level differences, make sure the site is level before
placing the machine on it.
-
Do not add decorations to the product that will cause its center of gravity to
be elevated. Also, be aware that there are cases in which it is illegal to add
electrical units to the product interior.
-
Make sure that the adjusters are always in contact with the floor.
-
Use rope, chain, and/or fixtures for securing furniture to secure the product so
that it will not fall down in an earthquake.
IMPORTANT