Need help?Do you have a question about the Seismic Source BOOM BOX 3 and is the answer not in the manual?
General| Brand | Seismic Source |
|---|---|
| Model | BOOM BOX 3 |
| Category | Controller |
| Language | English |
Crucial safety precautions when using the dynamite controller and explosives.
Details differences between Boom Box 3 and older Boom Box unit regarding cables and parameter loading.
Explains Autonomous and Standard Radio modes of operation for Boom Box 3.
Lists components of the Encoder and Decoder systems.
Description of controls, terminals, and LEDs on the front panel.
Describes the graphical display on the Boom Box 3 front panel and its messages.
Explains available Encoder modes, fire sequence, and start code requirements.
Operation, tests (Geophone, CAP, GPS), and fire sequence for Standard Decoder mode.
Operation and tests for OSEIS Decoder mode, including geophone, CAP, GPS, and fire sequence.
Operation of Boom Box 3 in Autonomous Mode, including setup and fire sequence.
Procedures for geophone, CAP tests, and GPS in Autonomous mode.
Operation and fire sequence for A3 Repeater Encoder mode.
Operation and fire sequence for A3 Repeater mode.
How to place Boom Box 3 into Monitor mode and its basic function.
Explains BB3/UE3 Encoder operation, fire sequence, and start code.
Operation of Boom Box 3 in BB3/UE3 Repeater Encoder and Repeater modes.
Overview of Boom Box 3 in RTM Mode Systems including connections and configurations.
Details Autonomous, Source-Driven, and Decoder-Driven operations in RTM mode with timing diagrams.
Wiring diagrams for RTM Encoder and Decoder Cables.
Detailed list of internal parameters for Boom Box 3 operation and their settings.
Pinout and function description for the 37-pin connector used for installation.
Instructions for setting up, connecting, and configuring parameters via the Wi-Fi interface.
Configuration steps for Autonomous mode and Wi-Fi GPS/shot assignment.
Exporting PFS and shot information, and recollecting data via Wi-Fi interface.
Setup and overview of SourceLink software for BoomBox3, including prospect and shot download.
Setup and operation of Source Control F3, including parameters and sequence tables.
Setup and operation of Source Control software, including parameters and sequence tables.
Details on operating modes (Encoder, Repeater, Decoder) and parameter setup within Source Control F3.
Wiring details for the 10-pin BB3 Decoder Cable and with GPS input.
Detailed diagrams for Boom Box 3 decoder cables and wiring.
Wiring diagrams for BB3 Ethernet and Autonomous fire switch cables.
To Next Page