Seismic Source BOOM BOX 3 - Monitor Mode; Monitor Mode Setup and Function

User’s Manual
28
8. Monitor
The Boom Box 3 can be placed into the Monitor mode by changing the operating mode to Monitor
through the Wi-Fi, SourceLink or Source Control F3 program.
The Monitor receives the radio start code from the BB3 Encoder and issues a Time Break pulse and
Recorder Start pulse 100 milliseconds before the Time Break pulse.
The Time Break and Recorder Start signals are adjustable by the Encoder Zero Time Adjust entry.
• Encoder Zero Time Adjust entry set to 2000 is the same as no delay.
• Encoder Zero Time Adjust lower than 2000 is a negative delay.
• Encoder Zero Time Adjust greater than 2000 is a positive delay.