Seismic Source BOOM BOX 3 User Manual

User’s Manual
90
14.3 Source Control Software setup
Source Control software can be used to communicate with the Boom Box 3 Encoder directly and
change original Boom Box decoder parameters over the radio.
Boom Box 3 to RJ45 cable needs to be connected to the computer and the Boom Box 3. The IP
Address of the computer needs to be assigned a static IP address as 10.x.x.x and Subnet Mask of
255.0.0.0.
All Firewalls and Anti-Virus programs which could block Ethernet communication needs to be
turned off.
14.3.1 Source Control Start and Setup
To start the Source Control program, click on the Source Control icon .
Click on Setup and Encoder Comm Settings…
The Communication Setup window will pop up. Set the Encoder Serial Port to Network. Set the
Encoder IP Address to the IP of the BB3 Encoder. This case it is 10.0.61.50. Set the Encoder IP
Port to 21234 and click on OK.

Seismic Source BOOM BOX 3 Specifications

General

Brand	Seismic Source
Model	BOOM BOX 3
Category	Controller
Language	English