Seismic Source BOOM BOX 3 User Manual

User’s Manual
92
14.3.2.1 Operating mode: BB Dynamite Decoder
Boom Box / Weight Drop Parameters section is used to change the parameters over the radio of
the original Boom Box and some parameters on the BB3 decoder. Only parameters for the Boom
Box in dynamite decoder mode can be changed.
Boom Box / Weight Drop Parameters section describe these entries.
Operating Mode: Use BB Dynamite Decoder
Start Code: Start code for decoder, 0 – 3.
Start Delay, usec: Start delay is also called decoder delay. This is the amount of time the decoder
waits to fire after receiving the radio start code.
Uphole Blank Time, msec: This entry is the amount of time to blank samples of the uphole
wavelet.

Seismic Source BOOM BOX 3 Specifications

General

Brand	Seismic Source
Model	BOOM BOX 3
Category	Controller
Language	English