Sencore MRD 5800 - Page 30

MRD 5800 – User Manual
Page 30 (116)
Mode
DVB-S
DVB-S2
Auto
This setting allows the user to choose
between DVB-S or DVB-S2 modulation
schemes. Setting to Auto will have the unit
automatically detect whether the input is
DVB-S or DVB-S2.
Satellite
Frequency
C-Band: 4GHz – 8GHz
Ku Band: 11.2Ghz –
14.5Ghz
L-Band: 950MHz –
2150MHz
Dependent on LO Offset
If LO Offset is set to 0 then L-Band frequency
is entered into the Satellite Frequency dialog
box. If LO Offset to set to a pre-defined
option then enter C-band or Ku-Band
frequency.
Wide Search
Enable
Disable
When Enabled the search range may be
extended depending on the symbol rate. See
appendix C for more information.
LO Offset
5150
9750
10600
10750
11250
The offset in MHz that the local oscillator is
operating.
Symbol Rate
Mode
Manual
Auto
The Manual option allows the user to choose
the symbol rate. The Auto option
automatically detects the incoming symbol
rate.
Note: Acquisition time may be longer in auto
mode, especially when the symbol rate is
below 1MSps or above 55MSps.
Symbol Rate
0 - 60
The symbol rate of incoming satellite signal
in MSps. Accurate to one decimal place
(kSps). Used when Symbol Rate Mode is set
to Manual.
PLS Code
0 – 262141
The MRD 5800 has the ability to receive
satellite signals scrambled using PL
Scrambling. In order to receive the stream,
enter the value of the incoming signals PL
Scrambling code.
LNB Power
Off
13 VDC
14 VDC
18 VDC
19 VDC
The MRD 5800 has the ability to provide the
necessary voltage to power an LNB. Select
the correct voltage to supply to the LNB.
22kHz Tone
Enabled
Disabled
Enabling or disabling the 22khz tone allows
the MRD 5800 to trigger the LNB to switch
polarities.
Multistream State
Enabled
The MRD 5800 has the ability to receive
multistream satellite signals. If the signal is