Need help?Do you have a question about the Sencore MRD 3187B and is the answer not in the manual?
General| Power Supply | 100-240 VAC, 50/60 Hz |
|---|---|
| ASI Output | Yes |
| Input Frequency Range | 950 MHz to 2150 MHz |
| Modulation Types | QPSK, 8PSK |
| Demodulation | DVB-S2, DVB-S |
| Video Output | HDMI |
| Audio Output | HDMI, Analog (RCA) |
| Input Level | -65 to -25 dBm |
| Video Decoding | MPEG-2, MPEG-4 |
| Audio Decoding | MPEG-1 Layer II |
| IP Output | Yes |
| Input Impedance | 75 Ohm |
Describes how to install the MRD 3187B unit into a rack, including cooling and power connection.
Provides essential steps to get the MRD 3187B unit operational, guiding through input, decoder, and output setup.
Details the minimal maintenance required for the MRD 3187B, focusing on cleaning the intake filter for optimal cooling.
Details the physical front panel of the MRD 3187B, including buttons and display layout.
Describes the rear panel of the MRD 3187B, illustrating its various connections and ports.
Explains the meaning of the front panel LEDs and indicators, aiding in status monitoring and error identification.
Outlines the slot numbering system (1-1 to 2-4) used for identifying and configuring input/output cards.
Details the specifications and function of the 8VSB/QAM receiver card for signal reception.
Describes the capabilities of the SD-SDI and Composite video output card, including embedded audio and captioning.
Explains the MPEG over IP card's functionality for transmitting and receiving IP streams, supporting redundancy.
Guides users on selecting the active input and configuring backup settings for input redundancy.
Provides detailed instructions for configuring the 8VSB/QAM receiver card via the front panel.
Offers step-by-step guidance for configuring the SD-SDI and Composite video output card settings.
Explains how to access the MRD 3187B's web client interface for remote configuration and management.
Provides an overview of the web client configuration menus, detailing how to navigate and set up the unit.
Guides users through setting the active input and configuring input card options via the web client.
Details how to set up services for decoding, explaining different setup options like Auto, PID-Locked, Priority, and No PSI.
Provides a list of acronyms and definitions used throughout the manual for technical clarity.
Lists and explains potential errors and events encountered with the MRD 3187B, aiding in troubleshooting.
Contains detailed technical specifications for the MRD 3187B base unit and its various option cards.
To Next Page
