Sencore MRD 3187B - Appendix C.e. Video Output (2 SD-SDI, 1 Composite) - Option 8704 A;8704 B

MRD 3187B - User Manual
Specifications are subject to change without notice.
Page 215 (245)
Appendix C.e. Video Output (2 SD-SDI, 1 Composite) – Option 8704A/8704B
SDI (Serial Digital Interface, Standard
definition) -
Standard:
ITU-BT.601/SMPTE 259M
Data Bit Rate:
270 Mbps
Number of Serial Video Outputs:
2 (Isolated)
Display Modes:
Letterbox, cropped, anamorphic
Embedded Audio Format:
SMPTE 272M
Sample Rates Supported:
32 – 48 KHz
Sample Rate Out:
48 KHz
Output Squelch:
Enable, (Output muted if no input detected)
Disable, selectable
Number of Embedded Audio Channel
Pairs:
4 (2 groups, each with 2 pairs)
Audio Types Supported:
DolbyE, AC3, MPEG2 layer 1 and 2, or PCM
Embedded Audio Control:
Selectable – “type”/disable
(each pair independently controlled)
Audio Type Standard:
Compressed (IEC 60958)
Uncompressed (IEC 61937)
Closed Captions:
Embedded - EIA-708B or EIA-608B
Line 21 – Enable/Disable (selectable) SDI and
Composite controlled simultaneously.
Connector:
(2) Female BNC
Impedance:
75 ohms
Composite Video Out –
Number of Outputs:
1 (NTSC/PAL)
Connector:
BNC, female
Impedance:
75 ohms, +/-10%
Return Loss:
>25 dB
Frequency Response:
DC to 6.0 MHz
Amplitude:
140 IRE (1.0 Vpp), +/-2 IRE
Display Modes:
Letterbox, cropped, anamorphic
NTSC -
Standard:
ANSI/SMPTE 170M-1994; CCIR656
Format, Frame rate:
525 lines, 29.97 Hz (Interlaced)
Setup (pedestal):
On/Off, selectable
Closed Caption:
Enable/Disable, selectable
CC Standard:
EIA-608B
PAL -
Standard:
ITU.R.BT.470-6
Format, Frame rate:
625 lines, 25.00 Hz (Interlaced)
Genlock –
SDI:
Line and Pixel Adjustment
Composite:
Line, Pixel, Color Phase Adjustment
Note: ac-3 and DolbyE are registered trademarks of Dolby Laboratories