Sencore MRD 3187B - Dual Video Output (2 SDI, 1 Rgbhv;Ypbpr;Composite) - Option 8708

MRD 3187B - User Manual
Page 63 (245)
4.9 Dual Video Output (2 SDI, 1 RGBHV/YPbPr/Composite) –
Option 8708
General Information
Install Location: 1-1 or (2-1 only on
Configuration 2 units or Configuration 1
units with dual decoders)
I/O: (2) 75Ω HD-SDI Female BNC outputs, (1)
15-pin D-sub Female analog output
Supported Formats: HD-SDI, SD-SDI,
YPbPr, RGBHV, and Composite
Description: This card provides three mirrored outputs from any of the available
input option cards. Two of the outputs are any combination of HD-SDI or SD-SDI
and one is analog YPbPr/RGBHV/Composite.
Output Control
1. Press the button.
2. Use the and buttons to move the
cursor to the “HD/SD SDI Anlg Video”
card of the specific slot (e.g. 2-1). Notice
the location diagram in the upper right
corner of the screen changes as the
cursor moves by each card.
Video Settings
1. Use the and buttons to move the
cursor to “Video”, then press the
button to display the Video Status screen
for the video output card.
2. Press the button again to display the
Edit screen for the video output card.
Select Format Setting
When in “Auto” mode, the unit will automatically pick the format which is closest
to the native format of the decoded video in the elementary stream. When in
“Manual” mode, the format may be selected from the list of available output
formats listed under “Video Format” below.
3. Use the and buttons to move
the cursor to “Select Format:” then
press the button.
4. Use the and buttons to
select either “Auto” or “Manual” mode,
then press the button to save the
selection.
SDI Anlg Vid 2-1
►Select Format:Manual
Format:1920x1080i
16x9 29.97
SDI Anlg Vid 2-1
►Video
HD Settings
SD Settings
Output
►HD/SD SDI Anlg Video
Audio 2-2