Sencore MRD 3187B - Lnb Power

MRD 3187B - User Manual
Page 99 (245)
1. Use the and buttons to move
the cursor to “Multistream:” then press
the button.
2. Use the and buttons to
select either (“Off”, “On”), then press
the button to save the selection.
ISI
Note: The setting of the “ISI” is only available when the “Multistream Mode” is set
to “On”.
1. Use the and buttons to move
the cursor to “ISI Mode:” then press
the button.
2. Use the and buttons to
select either (“Manual”, “List”), then
press the button to save the
selection.
Available ISI
The selection of ISI values are from the ones available within the multistream
input.
1. Use the and buttons to
select an ISI that is available in the
multistream input, then press the
button to save the selection.
Manual ISI
The ISI value is entered independent of the ISI values present in the input
multistream. This is used when the Source is being configured without the
source being the active input.
1. Use the and buttons to
select the column to edit and use
the and buttons to
change the ISI value (0 – 255),
then press the button to save
the selection.
LNB Power
LNB power is configurable separately for each Source input, but is only supplied to
the active source.
1. Use the and buttons to move the
cursor to “LNB Power:” then press the
button.
2. Use the and buttons to select
“Off”, “13VDC”, “14VDC”, “18VDC”,
“19VDC”, then press the button to
save the selection.
DVB-S/S2 1-4
DVB Mode:DVB-S2
►LNB Power:Off
22kHz Tone:off
DVB-S/S2 1-4
Multistream:Enabled
ISI Mode:Manual
►ISI:17
DVB-S/S2 1-4
Multistream:Enabled
ISI Mode:Manual
►ISI:17
DVB-S/S2 1-4
Multistream:Enabled
►ISI Mode:Manual
ISI:17
DVB-S/S2 1-4
DVB Mode:DVB-S2
►Multistream:Disabled
LNB Power:Off