Sencore MRD 3187B - Video Output (1 Rgbhv;Ypbpr, 1 Composite) - Option 8706 A

MRD 3187B - User Manual
Page 52 (245)
4.7 Video Output (1 RGBHV/YPbPr, 1 Composite) - Option
8706A
General Information
Install Location: 1-1 or (2-1 only on
Configuration 2 units)
I/O: (1) 75Ω Female BNC NTSC/PAL
Composite output, (1) 15-pin D-sub
Female analog output
Supported Formats: NTSC/PAL Composite,
YPbPr, RGBHV
Description: Analog only, video output card that can output either high definition or
standard definition formats. There are two outputs on the card. One BNC for
composite and one 15-pin D-sub for composite.
Output Control
1. Press the button.
Note: For Configuration 2 units, select RDS1 or RDS2, then press .
2. Use the and buttons to move the
cursor to the “Anlg Video” card of the
specific slot (e.g. 1-1), then press the
button. Notice the location diagram in the
upper right corner of the screen changes
as the cursor moves by each card.
Video Settings
1. Use the and buttons to move the
cursor to “Video”, then press the
button to display the Video status screen
for the video output card.
2. Press the button again to display the
Edit screen for the video output card.
Select Format Setting
When in “Auto” mode, the unit will automatically pick the format which is closest
to the native format of the decoded video in the elementary stream. When in
“Manual” mode, the format may be selected from the list of available output
formats listed under “Video Format” below.
1. Use the and buttons to move
the cursor to “Select Format:” then
press the button.
2. Use the and buttons to
select either “Auto” or “Manual” mode,
then press the button to save the
selection.
Video Format
Note: This menu is only available if the “Select Format” option is set to “Manual.”
Anlg Video 1-1
►Select Format:Manual
Format:1920x1080i
16x9 29.97
Anlg Video 1-1
►Video
Cmpst VBI Assignment
Overlay
Output
►Anlg Video 1-1
Audio 1-2