Sencore MRD 3187B - 4.2 8 VSB;QAM Receiver - Option 8701 A

MRD 3187B - User Manual
Page 27 (245)
Setting the Backup Mode
1. Use the and buttons to move
the cursor to “Backup:”, then press the
button.
2. Use the and buttons to select
“Enabled” or Disabled” and then press
the button to save the selection.
Setting the Primary Input
1. Use the and buttons to move
the cursor to the input shown as the
Primary Input, then press the
button.
2. Use the and buttons to select
the input option to use as the Primary
and then press the button to save
the selection.
Setting the Backup Input
1. Use the and buttons to move
the cursor to the input shown as the
Backup Input, then press the
button.
2. Use the and buttons to select
the input option to use as the Backup
and then press the button to save
the selection.
Setting the Primary Restore Setting
1. Use the and buttons to move
the cursor to the “Primary Restore”
setting, then press the button.
2. Use the and buttons to select
“Never”, “When Primary Rtns” or “On
Backup Failure”, then press the
button to save the selection.
Setting the Backup Timeout Setting
1. Use the and buttons to move
the cursor to the “Switchover:” setting,
then press the button.
2. Use the and buttons to select
the column to edit and use the and
buttons to set the value of the
timeout (3 – 45 seconds), then press
the button to save the selection.
Backup Mode
Primary Restore:
Never
►Switchover:05 secs
Backup Mode
MPEG/IP 1-3
Primary Restore:
► Never
Backup Mode
ASI/310M 1-2
Backup Input:
► MPEG/IP 1-3
Backup Mode
Backup:Enabled
Primary Input:
► ASI/310M 1-2
Backup Mode
►Backup:Enabled
Primary Input:
ASI/310M 1-2